To make a relative adjustment to the selected Registered Parameter's current value, use the Data Increment or Data Decrement controllers (Control Numbers 96 and 97).Green OA: This type of Open Access includes peer-reviewed articles that are in their pre- or post- print versions. If the selected Registered Parameter requires the LSB to be set, send another Control Change message to the Data Entry LSB controller (Control Number 38).ģ. To set the selected Registered Parameter to a specific value, send a Control Change messages to the Data Entry MSB controller (Control Number 6). Send two Control Change messages using Control Numbers 101 (65H) and 100 (64H) to select the desired Registered Parameter Number, as per the following table.Ģ. To set or change the value of a Registered Parameter:ġ. Poly Mode On (+ mono off, +all notes off) Note: This equals the number of channels, or zero if the number of channels equals the number of voices in the receiver. Mono Mode On (+ poly off, + all notes off) Non-Registered Parameter Number (NRPN) - MSBĬontroller numbers 120-127 are reserved for Channel Mode Messages, which rather than controlling sound parameters, affect the channel's operating mode. Non-Registered Parameter Number (NRPN) - LSB (default: Chorus Send Level - see MMA RP-023)Įffects 4 Depth (formerly Celeste Depth)ĭata Increment (Data Entry +1) (see MMA RP-018)ĭata Decrement (Data Entry -1) (see MMA RP-018) (default: Reverb Send Level - see MMA RP-023) Sound Controller 10 (default undefined - see MMA RP-021) Sound Controller 9 (default: Vibrato Delay - see MMA RP-021) Sound Controller 8 (default: Vibrato Depth - see MMA RP-021) Sound Controller 7 (default: Vibrato Rate - see MMA RP-021) Sound Controller 6 (default: Decay Time - see MMA RP-021) Sound Controller 4 (default: Attack Time) Sound Controller 3 (default: Release Time) Sound Controller 2 (default: Timbre/Harmonic Intens.) Sound Controller 1 (default: Sound Variation) LSB for Control 19 (General Purpose Controller 4) LSB for Control 18 (General Purpose Controller 3) LSB for Control 17 (General Purpose Controller 2) LSB for Control 16 (General Purpose Controller 1) LSB for Control 11 (Expression Controller) LSB for Control 7 (Channel Volume, formerly Main Volume) LSB for Control 1 (Modulation Wheel or Lever) Table 3: Control Changes and Mode Changes Appended at the bottom is a table of all currently defined RPNs. Registered Parameter Numbers (RPNs) are an extension to the Control Change message for setting additional parameters. We strongly recommend consulting the official MMA Detailed MIDI Specification for additional information. WARNING! Details about implementing these messages can dramatically impact compatibility with other products. Valenti-Electronic Musician 2/88, and updated by the MIDI Association.) This table is intended as an overview of MIDI, and is by no means complete. The following table lists all currently defined MIDI 1.0 Control Change messages and Channel Mode messages, in control number order (adapted from "MIDI by the Numbers" by D. Table 3 - Control Change Messages and RPNs
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |